Precautions for the use of ice machines

Ice machine should be installed away from heat sources, no direct sunlight, well-ventilated place, the ambient temperature of the ice machine should not exceed 35 degrees Celsius.

The ambient temperature of the ice maker should not exceed 35 degrees Celsius, in order to prevent the ambient temperature from being too high, resulting in poor heat dissipation of the condenser, affecting the effect of ice making. The ground where the ice machine is installed

The ground should be solid and level, and the ice machine must be kept horizontal, otherwise it will not remove ice and produce noise during operation.

The gap between the back and the left and right sides of the ice machine should not be less than 30cm, and the gap at the top should not be less than 60cm, and the ice machine should use an independent power supply.

The ice machine should use independent power supply, special line power supply and equipped with fuse and leakage protection switch, and should be reliably grounded.

The water used in the ice machine should be in line with the national drinking water standard, and install water filtration device to filter the impurities in the water, so as not to block the water pipe of the ice machine and pollute the ice machine.

Machine water pipes, contamination of ice machine sinks and ice moulds. And affect the performance of ice.

Handling ice machine carefully and gently, to prevent violent vibration, handling ice machine slope can not be less than 45 degrees, after long-distance transport, the ice machine should be static.

After long-distance transport, the ice machine should be placed in a static position for 2-6 hours before opening the ice machine.

When cleaning the ice machine should turn off the power supply, it is strictly prohibited to use the water pipe directly to the ice machine body rinse, should be neutral detergent scrub, it is strictly prohibited to use acidic, alkaline and so on.

Acidic, alkaline and other corrosive solvents are strictly prohibited to clean the ice machine.

Ice machine must be two months turn on the water inlet hose pipe head, clean the water inlet valve filter, to avoid impurities in the water sand and mud clogging ice machine

Water inlet, causing the water inlet to become smaller, resulting in no ice.

Must be cleaned every two months ice machine condenser surface dust, condensation and heat dissipation will cause ice machine compressor parts damage.

Bad. When cleaning, use hoover, small brush to clean the condensing surface oil dust, can not use sharp metal tools to clean, so as not to damage the ice machine condenser.

Damage to the ice machine condenser.

The water pipe, water tank, refrigerator and protective film of the ice machine should be cleaned once every two months. When not in use, it should be cleaned

When not in use, it should be cleaned and dried with a hairdryer to dry the ice mould and moisture inside the box, and the ice machine should be placed in a place without corrosive gases and ventilated and dry, avoiding open-air storage.